Jacks GT0102 used with passenger cars and loads not exceeding the weight of 2 t. Pickup height is 135 mm, and the maximum lifting height is 345 mm. Jacks are often used in tire fitting and repair shops. They are very convenient to move, there are four wheels, two of which are rotated. the installation location of the jack are specified in the vehicle manual. The jack must stand on a flat hard surface. Otherwise, it may tip over. Car wheels need to slow down and substitute for them stops. Jack is driven rubberized handle of the pump, which is attached. In order to lift the load, it is necessary to fix the handle and close the shut-off valve by turning the handle clockwise. Hydraulic jacks raise the load for a short time, since under the action of the load, the working fluid flows slowly through the sealing ring and the ram descends. To hold the load in the raised position, and security necessary to use support under the machine. To lower the load, turn the handle counterclockwise.