The filter for air purification with gear 1/2 ", 5 m, 2500 l / min, metal, professional PT-1418 Intertool

Air filter with a reducer is needed for high-quality paint spray gun or for smooth operation and pneumatic equipment. Safeguard your instrument from contamination, premature wear and extends the service life. Clean air from the compressor of the moisture, oil, dust and other minute particles, as well as impurities. Filtration Level 5 microns. The case is made of durable high quality metal not subject to corrosion, guaranteeing a long filter life and high operating pressure. The protective housing is placed a transparent bulb, inside the filter element is made of synthetic fibers, as well as guides for the creation of air turbulence. The main body of the gearbox is also set, you can easily put the necessary pressure in the line. Pressure gauge with double precision scale PSI, bar in a metal housing, with a maximum of 16 bar. It can be mounted on both sides of the filter, if necessary. At the bottom of the bulb installed automatic condensate drain valve. It has 2 positions: manual and automatic drain. In automatic mode, the drain valve will reset the residual moisture and oil when the pressure in the system at least 0.5-1 bar. Air filtration Duplex: using centrifugal force, and through the filter element. Included with filter supplied fasteners moisture separator for mounting on vertical surfaces. Properties filter element is made of synthetic fibers; Fine filtration 5 m; Automatic and manual drainage; Precise pressure setting in the system; Robust metal housing for protection of the bulb; Metal mounts for mounting on vertical surfaces. It is recommended to install a filter as possible to the air consumer or directly at the outlet of the compressor. The filter element must be cleaned when dirty. Immerse the cartridge in an alcoholic or other cleaning solution for 30 minutes or more, then carefully blow air. If necessary, replace the filter element, replace with a new PT-1452. The kit does not include adapters. It has 2 internal thread for connecting with a diameter of 1/2 ".