12V-24V, 300A, 1.2kVt AT-3016 Intertool puskozarjadnoe device

Puskozarjadnoe device AT-3016 is intended for charging batteries with a voltage of 12V or 24V to 700Ach and capacitance, as well as for starting a vehicle engine together with a 12V or 24V battery. AT-3016 puskozarjadnoe device has a metal housing and has a high reliability and quality assembly of all components and ERE. Power consumption device is 1600W, 230V supply voltage. Three toggle switches on the front panel of the unit responsible for the operation puskozarjadnoe device, a fourth switch (the largest) is responsible for the unit's power ( "On. / Off.") The lower part of the front panel has two outgoing 12V and 24V terminals to select the battery charging mode battery and one central effluent cable terminal clamp "-". AT-0316 puskozarjadnoe device is intuitive and user-friendly interface with a digital display of the charging current. How do I charge the battery? The red cable is connected to terminal "+12" or "+24", depending on the voltage of the battery being charged. mode switch "1-2", set to "1". Switch "Less - More" set to "Less". Switch "Charge - Start" set to "Charge". With the help of terminals connect the device to the battery, respecting the polarity. After all the procedures, connect the device to the network 230. Turn on the device by setting the front panel switch to "On." When fully charged the battery indicator displays a digital value close to zero. Digital display shows the charging current. Depending on the condition of the battery and the manufacturer's recommended charging currents of the battery, set the switch "1 - 2" and "Less - More" to the desired position. When charging is complete switch to "On. / Off." set to "Off." Disconnect the power cord ROM by holding the plug, and then disconnect the terminals from the battery contacts. Start the engine with the AT-3016 (not recommended to start the engine with an integrated on-board computer) First we need to make the usual charge the battery for 20-40 minutes. Switch "Charge - Start" set to "Start". Switch to "On. / Off." set to "On." and at the same time make the engine run. Digital indicator indicates when starting the engine the maximum starting current. If within 10-15sek. the engine does not start, then restart manufacture in 5-10 minutes. After the end of engine start switch to "On. / Off." set to "Off." Disconnect the power unit from the mains cable, hold the plug. Disconnect the terminals from the battery contacts. Store charger must be indoors at a minimum humidity and at ambient temperatures from -10 ° to + 30 ° C. For prolonged storage charger with an ambient temperature of less than -10 ° C before turning on the device allow it to warm indoor heat at least 1 hr.