Puskozarjadnoe device 6V-12V, 220V, 70A AT-3013 Intertool

AT3013 puskozarjadnoe device will help to start the car when the battery is too weak to start the engine. This device can be charged to the rechargeable battery capacity 100 Ah powered DC 6V and 12V. AT3013 puskozarjadnoe device connects to the network with a voltage of 230V and 50Hz network. Front panel device puskozarjadnoe AT3013 sufficiently informative and understandable. It has two switches and two LEDs. How to make the battery charging status? Before you begin charging, remove the battery from the vehicle. Then the switch "function selection" set to "Charge" and switch "settings" in the position corresponding to the battery voltage. Turn the device on the network, dial indicator on the panel shows the charging current. With a fully charged battery the needle is near zero. When charging indicator lights on the front panel puskozarjadnoe device. Do not forget about the polarity when connecting the device to the battery. How to start up the engine using puskozarjadnoe AT3013 device? First you need to charge the battery during 2040min. After that, you must set the switch "function" in the right position, and the switch "settings" in the leftmost position, the indicator lights up, "charging is completed." Then you can start the engine. If, during the 1015 s. engine fails to start, the next attempt should be made after 10 minutes. The "End of charging" the engine turns off at startup. Store charger must be indoors at a minimum humidity and an ambient temperature of 10 ° C to + 30 ° C. For prolonged storage charger with an ambient temperature less than 10 ° C before turning on the device allow it to warm indoor heat at least 1 hr. We strongly recommend that you, before you get to work, get acquainted with the operating instructions!