Bus connector (comb) 3P 63A ElectroHouse

a connecting bus (comb) PIN 3P 63A & nbsp; EH-BB-363 & nbsp; & nbsp; It used to connect the circuit breakers, RCD, differential-machines and other devices & nbsp.; It is designed for certain supply voltage phases and poles to protect the devices by their parallel connection. That is a substitute homemade jumper wire from the mounting. The most advisable its use in large switchboards. It is simple to use and very reliable device. It is durable and complies with international and European standards kachestva.Konechno can use the old way to connect a jumper wire from the installation, but this method has some significant drawbacks - jumpers often interfere connect electric equipment on DIN-rail level above, extra wires in the electrical panel not look just not aesthetically pleasing, but also often interfere with closing the lid assembly and a longer time-consuming (because you need to measure and cut the wires in length, bend, clean, choose a tip, pressurize with the help of pressing tongs, etc.) When mounting using connecting bus (comb) these disadvantages there, but there are a number of advantages - higher quality connection (when connection jumper is represented by two wire ends in a single terminal, then the application & quot; comb & quot; reduces this value to 2 times that positively affects the quality of the contact), substantially excludes overheating pad and related e Tim problems in the panel reduces the number of wires, which makes wiring more reliable, accurate and intuitive, fast and easy installation which can handle almost any chelovek.Konstruktivno is a three-piece brass plate in the plastic insulation off of these pins. Tires are isolated from each other. The plate and the pins are of unitary construction without the joints. This model combs tires - three-pole, nominal current for the device - 63A. The number of input conductors - 54 (18 per tire). conductor thickness 1.1 mm and width - 4 mm.Ona designed to operate at a temperature of from -60 to + 60C, and an average value of humidity not exceeding 90%. The length of this device & ndash; 1 m & nbsp.; The pins are spaced 18 mm. The number of pins on each bus - 18.